Volt Latency Change Problem?

Discuss software bugs and related problems here.

Moderator: Matt

Post Reply
bmitchell_ga
 

Posts: 3
Joined: Fri Feb 06, 2009 7:45 pm

Volt Latency Change Problem?

Post by bmitchell_ga »

I am having a problem with electrical load detection. I was told that using the Volt Latency Change might could solve my problem, but my version of Nistune dosen't have that option. Here is a screen shot from Brandon at AVP.

Image

Here is a screen shot from my pc not showing VLC

Image

I know I am running Vista and there are a few differences but I have tried it in XP with the same result. Am I doing something wrong?
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Post by Matt »

you are using an older version of nistune. Use the latest beta version and it will pick up the extra parameters
bmitchell_ga
 

Posts: 3
Joined: Fri Feb 06, 2009 7:45 pm

Post by bmitchell_ga »

I just downloaded the neweset beta and nothing has changed. The version I was using was the 10/11/2009 release. So it wasn't that old either.
TM_S13
 

Posts: 246
Joined: Mon Dec 29, 2008 11:29 pm

Post by TM_S13 »

are you using the same address file ?
it doesn't seem like so, since the output/look is quite diferent on the left table... yours isn't divided and identified like the latest address files...
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Post by Matt »

yeah thats what I was thinking. point your address file location to where you installed Nistune

eg
c:\Program files\Nistune\Address

Then reopen the address file for your vehicle from the list.
bmitchell_ga
 

Posts: 3
Joined: Fri Feb 06, 2009 7:45 pm

Post by bmitchell_ga »

I got it now. Thanks guys :D




Image
TM_S13
 

Posts: 246
Joined: Mon Dec 29, 2008 11:29 pm

Post by TM_S13 »

nice ;)
martinbattye
 

Posts: 8
Joined: Tue Feb 02, 2010 3:19 am

Re: Volt Latency Change Problem?

Post by martinbattye »

voltage latency change needs to be set out as a table..

presently the numbers mean nothing.
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Volt Latency Change Problem?

Post by Matt »

Agreed it does not make sense since its displayed as a raw number currently

Voltage latency in nissan ECUs is not a table. It is a calculation based on the battery voltage. See here details:

viewtopic.php?f=12&t=707&p=4242&hilit=latency#p4242

Eric reverse engineeered it from the Z32 ECU code. Not too sure if others are similiar (probably should be) but given both memory addresses in the address file I should be able to decode that one

The best way to do this is to display a table with 0-15 volts with a single raw value editable which then displays the ms effected for each voltage in the table. It would need to be a customised window as opposed to the generic forms I use for displaying data at the moment
Post Reply