Logging problem in Injector duty cycle/time???

Discuss software bugs and related problems here.

Moderator: Matt

Post Reply
Christian
 

Posts: 24
Joined: Sun Mar 29, 2009 5:29 am
Location: Austria

Logging problem in Injector duty cycle/time???

Post by Christian »

Hello

I did a long run with the new wideband connected and noticed that sometimes the values for injection time/duty cycle are odd.

It can be clearly seen at 45 minutes 30 seconds that with full throttle from low revs upward duty cycle is 24% max, then at 2475 suddenly drops to 12%. AFR stays in realistic regions, so I suspect the injector duty to be false.

I used
Nistune 0.9.13.1b
Type 1 V4 board
Techedge 2Y
The car is a european 180SX (200sx here) CA18DET RS13
Adress file is from ROM Pack 2.1 S13_CA18DET_128_E.adr

Cheers
Christian
Attachments
NIStune_2009-09-07_2208_39.zip
(565.79 KiB) Downloaded 145 times
streetbike
 

Posts: 69
Joined: Sat Jan 19, 2008 11:44 pm
Location: toulouse FRANCE

Post by streetbike »

same problem but at higher rpm on ca18det too.

seems that it happens at a certain amount of injection. ( switch from sequential to batch fire injection)
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Post by Matt »

its the ECU switching injection mode from what I can see....

the raw injection time reported by the ECU changes also, so its not just our duty cycle calculation

see pic
Attachments
duty_cycle2.JPG
injection time change
(67.45 KiB) Downloaded 2799 times
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Post by Matt »

also fixed up the navigation on the logger, slider wasnt working too well in a log this size
streetbike
 

Posts: 69
Joined: Sat Jan 19, 2008 11:44 pm
Location: toulouse FRANCE

Post by streetbike »

Is there any way to override the calculation to force the real injection time ?

Or is there a fixed factor of "2" between consult and "real" ? so when consult gives 50% duty it is 100% in real ?
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Post by Matt »

we would need to know from the ECU that it is switching. im not sure how we could determine this to alter the display so it appears more accurate
streetbike
 

Posts: 69
Joined: Sat Jan 19, 2008 11:44 pm
Location: toulouse FRANCE

Post by streetbike »

Matt wrote:we would need to know from the ECU that it is switching. im not sure how we could determine this to alter the display so it appears more accurate
I have searched in all my logs If I can see something same each time it happens. but no way.....
It is not RPM based, sure of that .

but I think it is based on the TP, as it happens at low rpms with stock turbo and later with bigger turbo.
about 2500-2700rpm with T25
3200-3500 with my gt2871
and 3800rpm with the gt3071

I thought it was when injector time was above 8ms because on my car, it happens each time before this time.
but I saw on the log above that it happens after 11ms on his car...
Post Reply