DLP + innovate lc-1 db gauge

Anything related to the DLP Devices IO-8 A/D converter

Moderator: Matt

Post Reply
fluked777
 

Posts: 4
Joined: Sat Dec 25, 2010 3:11 am

DLP + innovate lc-1 db gauge

Post by fluked777 »

Hi everyone, i spliced into my analog 2 wire(brown) from the lc1 wideband which was running my airfuel gauge (innovate db)

Since i have spliced the wire into the dlp converter it changed my air fuel ratio from the previous reading (14.3) at idle to 12.7
in nistune i connect wideband via serial cable and see i have the correct readings (14.3 at idle) but my gauge shows the 12ish, this is annoying me, im stumped.

By unplugging the splice from dlp converter my gauge instantly reads the correct air fuel.

Thanks
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: DLP + innovate lc-1 db gauge

Post by Matt »

Sounds like the DLP is pulling your LC-1 output lower. Would be a question for the Innovate Support people.

I can try it out on my LC-1 when I get a chance. From memory never had a problem previously. As long as all grounds are correct then normally should not cause an issue
Post Reply