Zeitronix EGT shows different in Nistune

Anything related to the Zeitronix brand of wideband devices.

Moderator: Matt

s14unimog
Posts: 5
Joined: Tue Jun 09, 2009 12:20 am
Location: Georgia
Contact:

Zeitronix EGT shows different in Nistune

Postby s14unimog » Sat Jul 10, 2010 7:19 am

Not sure if this has been discussed but I couldn't find it anywhere. My Zeitronix's communicates without a problem, but my EGT display's differently than what is on my Zeitronix DRO. The temperatures shown in Nistune are significantly lower; could it be set to C* or something; I'll have to double check if that is what's showing. If that is the case, I would prefer to see imperial units... Am I missing some configuration window?

Has anyone seen this symptom?

Any thoughts Matt?


Thanks,
Brandon

Matt
Site Admin
Posts: 8038
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Zeitronix EGT shows different in Nistune

Postby Matt » Mon Jul 12, 2010 11:04 am

Yes it shows degrees for that unit. Not sure about F*

Okay just looked at the Zeitronix protocol they supplied

Data block: data format
AFR HEX 8 bit
EGT LSB HEX 16 bit
EGT MSB HEX 16 bit


I assume the EGT is C* but it is not very clear. There was a config bit for the LCD to change between C and F but apparently we dont use that


Return to “Zeitronix”

Who is online

Users browsing this forum: No registered users and 1 guest