Incorrectly installed board

Discuss hardware problems here.

Moderator: Matt

Post Reply
raddy
 

Posts: 167
Joined: Mon Mar 16, 2009 9:52 pm

Incorrectly installed board

Post by raddy »

Hi Matt,recently I have got s14a ecu with type 4 board. I found that flat cables of board adaptor are soldered into the fcu without 1st. pin offset,both cables was 1 to 1. I removed that cable which need offset and installed it correctly and filled 1st hole with solder. Engine can start now (wasnt possible before), but its not possible to connect to ecu with nistune. Its possible that board is (at least) partially damaged? Would you advice to replace board or also ecu?
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Incorrectly installed board

Post by Matt »

Would need the board here to inspect. It shouldnt be damaged but difficult to tell anything without posting it here
Post Reply