fatal disconnects

Discuss hardware problems here.

Moderator: Matt

Post Reply
bachig24u
 

Posts: 677
Joined: Mon Jun 01, 2009 11:46 pm
Location: Campbelltown, NSW
Contact:

fatal disconnects

Post by bachig24u »

Hi Matt,
I finally installed a type 1 board I purchased a while back...
also had a hard/software issue with an older tried and tested type 1board.

26/03/12
vehicle 1:
Been getting fatal disconnects, and what appears to be usb bus hang requiring physical disconnect/reconnect to get consult working.

I have attached the log files which had the error recorded in them.
Didn't seem to need to open close nistune to recover from them.

On 14/03/12
vehicle 2:
had a situation on a different type 1 board and vehicle where nistune locked up and became non-responsive, I was unable to end task, I tried opening another instance and found that I could not end either of them.
only way to resolve was reseat usb which allowed nistune to let go of its locked up state and close.

machine: W7 32bit bare bones flavour for ecm apps only with MSE for base virus protection.
Attachments
system-events.zip
(2.38 MiB) Downloaded 240 times
app-events.zip
(650.49 KiB) Downloaded 257 times
logs.zip
(2.65 MiB) Downloaded 248 times
Post Reply