I am building a S13 EUDM with a sr20det black top from a S14 zenki jdm version. ECU Type: WH 23710 75F00
Recently i have installed a new pro wiring harness from wiring specialties. The problems appeared before the wiring installation, so i thought i have a crappy wiring.
Before i install my type 2 board i want to bring the engine to stock settings.
I have a weird problem at idle, the engine O2 sensor is showing values unter 0.2 Volts. Are these values normal? I have been told that the value should be between 0.6 - 0.8 Volts. O2 sensor (thick version) is brand new. (csv attached)
- 1539_30 csv table is driving on first gear inside a garage
- 1507_29 csv table is car idling and standing
I am getting also a fault code 34 knock sensor. My knock sensor is brand new and the wiring to the ecu too. I have checked the wiring for continuity and also the pin numbers.
Could you please help. Thanks.
Post here where your issue is not tuning specific but more of a sensor or mechanical issue
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest