Whats stock boost for S13 S14 SR20DET

If you know what B.S. stands for you know what goes here.

Moderator: Matt

Post Reply
UNISA JECS
 

Posts: 367
Joined: Wed Jun 04, 2008 3:48 am
Location: USA Socal

Whats stock boost for S13 S14 SR20DET

Post by UNISA JECS »

Hey Matt got a simple question what is the factory boost pressure for the above mentioned vehicles when they come off teh dealer lot?

More here on this:

http://zilvia.net/f/tech-talk/208005-wh ... 20det.html
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Post by Matt »

Checked with PL on this one since I only work the software/firmware side of things...
8 to 10psi is the answer for S13. The stock WG actuator spring gives 7 to 8 psi. But then there are two brass bleed jets hidden in the hoses that give you your actual boost level. The ratio of the two jet sizes determines the boost level – not the friggin solenoid

Stock boost is very hard to nail down cos you only need to fart and it’ll change. Have a look at the graphs for Graeme’s dead stock S15. All I did was tune the fuel and IGN maps a bit and boost crept up by over 1psi – no other changes. This proves that a stock S15 is 8psi though!

http://www.plmsdevelopments.com/customers/gf_s15.htm
Post Reply