backfiring....

If you know what B.S. stands for you know what goes here.

Moderator: Matt

Post Reply
datsunboy
 

Posts: 106
Joined: Thu Mar 15, 2007 1:51 pm
Location: New Zealand

backfiring....

Post by datsunboy »

hey guys.....I had my first decent play with nistune today....
its a CA18 with a T28, 550cc inj, and Z32 MAF.
were running 45psi fuel pressure.

we only had a bit of a play....but we got it to run pretty close to 14.7 at idle....but it was still a bit rich up top, but we'll play with that more later.

problem id, that its backfiring real bad on decel?

it idles a little rough, which I think is because I havent set the latency up properly yet.....any tips on doing that?.....could that be causing the backfiring?

heres a very quick log file ( the log file stops recording all by itself???? )
Attachments
NIStune_2008-04-06_1655_14.csv
(214.85 KiB) Downloaded 172 times
Fusion Ed
 

Posts: 281
Joined: Fri May 04, 2007 4:13 am
Location: Chertsey Surrey
Contact:

Post by Fusion Ed »

Backfiring on over run is a lean condition (not really dangerous in any way) Is the TPS working correctly? It needs to detect when the throttle is closed to cut off the fuel supply.
datsunboy
 

Posts: 106
Joined: Thu Mar 15, 2007 1:51 pm
Location: New Zealand

Post by datsunboy »

wierd, I wouldve thought that backfiring was due to too much fuel
but the wideband was off the chart lean.....lol
the TPS appears to be working....i remember the TPS closed light on the cosult display being on when were were tuning in the driveway....
but if you look through the log file....it says TPS is still reading 0.3volts on decel.....maybe its not set properly then? I'll take a look at it
thanks for the quick suggestion 8)
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Post by Matt »

yeah when TPS indicates acceleration pedal released, if above RPM in the fuel cut table for specified temp is then fuel should be cut until Fuel Recover RPM is reached for specified temp
datsunboy
 

Posts: 106
Joined: Thu Mar 15, 2007 1:51 pm
Location: New Zealand

Post by datsunboy »

while your here matt.....have a look at that log.....its showing me values of TP of like 2000-4000 ??????
Post Reply