CA18DET RS13 revs raise when in gear but statinary

If you know what B.S. stands for you know what goes here.

Moderator: Matt

Post Reply
rads_s13
 

Posts: 27
Joined: Thu Aug 04, 2011 1:04 am
Location: U.K.

CA18DET RS13 revs raise when in gear but statinary

Post by rads_s13 »

weird one, I pulled on to my driveway and opened the garage door got back in the car and put it in gear and noticed that the revs raise by 400-500 rpm take it out of gear again and the revs dropped again. I thought that was very odd. so tried putting it into each gear and it did the same thing, put it in to gear the revs raise take it out the revs drop again. has anyone had this happen or any ideas what might be coursing it. it didn't do it at the start of the drive.

Cheers
Richard
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: CA18DET RS13 revs raise when in gear but statinary

Post by Matt »

Idle RPM table usage. Timing is adjusted based on neutral switch and affects the RPMs accordingly
rads_s13
 

Posts: 27
Joined: Thu Aug 04, 2011 1:04 am
Location: U.K.

Re: CA18DET RS13 revs raise when in gear but statinary

Post by rads_s13 »

Hi Matt, thanks for that, along with this symptom which only started happening after I drove home from an event last night, today I connected my laptop this evening and the car has also started running on the correct maps (screenshop attached) and it now has a really lumpy idle. I haven't been able to get my board reprogrammed yet so it is still a jap non cat in a europe ECU.

Cheers
Richard
Attachments
nistune running 301011.JPG
(124.06 KiB) Downloaded 2507 times
Post Reply