Australian Users

If you know what B.S. stands for you know what goes here.

Moderator: Matt

Post Reply
Bernardd
 

Posts: 253
Joined: Thu Jan 26, 2006 3:20 am

Australian Users

Post by Bernardd »

Anyone know someone with a jatco and pro ratchet installed? I've picked one up for my 3n71b and need the length of the lever used at the transmission. Or a good way of calculating it based on the stock lever length.
bachig24u
 

Posts: 677
Joined: Mon Jun 01, 2009 11:46 pm
Location: Campbelltown, NSW
Contact:

Re: Australian Users

Post by bachig24u »

The lever is only 1.75 - 2 inches long.
When installing the proratchet you need to bolt the cable holder to the inside of the shifter base even though the outside looks more logical. not sure if thats what you are trying to fix but it enables the ratchet to lock properly on in the gears and lines up all the switches for most transmissions I've come across.
bachig24u
 

Posts: 677
Joined: Mon Jun 01, 2009 11:46 pm
Location: Campbelltown, NSW
Contact:

Re: Australian Users

Post by bachig24u »

did you sort this?
Bernardd
 

Posts: 253
Joined: Thu Jan 26, 2006 3:20 am

Re: Australian Users

Post by Bernardd »

Yes I did. I made the flat bar on the trans the same lenght as the throw of the shifter.
I went back to a stock shifter. The ratchet shifter sits too high on the console and since the trans was already installed, I'd have to cut the console or remove the trans again to make it fit the way I wanted it to. Next time the trans is out I'll install it with a box in the trans tunnel to lower the shifter to the desired location.
Post Reply