Homemade Twinscroll manifold

If you know what B.S. stands for you know what goes here.

Moderator: Matt

Post Reply
Mads B (dk)
 

Posts: 74
Joined: Sat Mar 22, 2008 7:39 am
Location: Denmark

Homemade Twinscroll manifold

Post by Mads B (dk) »

PL
 

Posts: 957
Joined: Fri Feb 03, 2006 3:29 pm
Location: Adelaide, South Oz
Contact:

Re: Homemade Twinscroll manifold

Post by PL »

Brilliant - I love it!!

I've done a few manifolds from steampipe bends and it works great. Albeit a little time consuming...

What turbo are you using?

PL
kenbam
 

Posts: 131
Joined: Sat Sep 15, 2007 9:46 am

Re: Homemade Twinscroll manifold

Post by kenbam »

Mads B (dk)
 

Posts: 74
Joined: Sat Mar 22, 2008 7:39 am
Location: Denmark

Re: Homemade Twinscroll manifold

Post by Mads B (dk) »

PL wrote:Brilliant - I love it!!

I've done a few manifolds from steampipe bends and it works great. Albeit a little time consuming...

What turbo are you using?

PL
Im runing a cheap china T3/T4 "trim O" @ 1.6bar
skylinegtrhr
 

Posts: 301
Joined: Sat Jun 21, 2008 1:50 am
Location: Croatia
Contact:

Re: Homemade Twinscroll manifold

Post by skylinegtrhr »

Nice project we have FR TS GT3076 kit on SR and results are great , we have 0,7 bar on 1800 rpm on dyno
but You should put thermo coating on manifold and DP or You are going to have very high under bonnet temperature.
And make extra braces for turbo as You have down mount which "like" to make cracks on manifold from weight of turbo and vibration of engine.
And if You can go for full TS set up with two WG ...
Torque
 

Posts: 639
Joined: Wed Jun 16, 2010 10:08 am

Re: Homemade Twinscroll manifold

Post by Torque »

Mads B (dk) wrote: Im runing a cheap china T3/T4 "trim O" @ 1.6bar
Are these China Turbos any good at all?
I saw many of them @ EBAY ...
Mads B (dk)
 

Posts: 74
Joined: Sat Mar 22, 2008 7:39 am
Location: Denmark

Re: Homemade Twinscroll manifold

Post by Mads B (dk) »

this one is okay and the most journal bearing turbos are..... but the china roller bearing ones are shit
Mads B (dk)
 

Posts: 74
Joined: Sat Mar 22, 2008 7:39 am
Location: Denmark

Re: Homemade Twinscroll manifold

Post by Mads B (dk) »

1.8bar boost (on the road i have fullboost at 4500-4700rpm)
Attachments
IMG297.jpg
(244.92 KiB) Downloaded 5254 times
Post Reply