Trouble connecting to LC-1

Anything related to the Innovate brand of wideband devices.

Moderator: Matt

Post Reply
msaunders
 

Posts: 22
Joined: Mon May 10, 2010 9:52 am

Trouble connecting to LC-1

Post by msaunders »

Hi all,
Just got Nistune and the WB02 installed and am trying to configure everything for the first time.
For some reason I'm unable to get the LC-1 to show up in Nistune. Logworks and LM Programmer work and I can program both units via usb/serial adapter (in my case com7). I believe I have Nistune correctly configured with com7 and the Innovate lookup tables referenced but when I hit connect it says device not found. Any ideas?
Thanks

edit - had conflicting com ports setup on my machine, oops!

Can connect and get proper AFR in Logworks, but it just reads 32afr in Nistune
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Trouble connecting to LC-1

Post by Matt »

Run through config again in Nistune

Reselect Innovate MTS in the drop down, resleect correct COM port
Check wideband folder is MTS

If that doesnt work, select something else (different unit) and then OK and then open up config again and do MTS

If that doesnt work let me know
msaunders
 

Posts: 22
Joined: Mon May 10, 2010 9:52 am

Re: Trouble connecting to LC-1

Post by msaunders »

Got it sorted, thanks Matt
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Trouble connecting to LC-1

Post by Matt »

Okay was reselecting the fix then?
Post Reply