Page 1 of 1

[FP] raising boost

Posted: Fri Apr 29, 2016 12:38 am
by FreakensNL
Have been reading a lot but something is not quite clear;

If I raise the boost, and go above the original max load of 104, I go outside the map..
Raise the K to lower the load but that means my hole map should move a little too the left??
So at lower TP values there should be less timing and more fuel

Did I miss this part in the documentation?

Re: [FP] raising boost

Posted: Fri Apr 29, 2016 12:58 am
by Matt
Lower K to reduce TP (load) and then any fuel you need to add, increase Total Injection Multiplier