Page 1 of 1

Utilising built in ADCs on nistune boards.

Posted: Tue Jul 04, 2017 5:53 am
by vanepico
Hi guys,

I'm looking to use my AEM uego, as well as an intake air temp and boost sensor with the 0-5v ADCs mounted on the nistune board, but I can't for the life of me find any information about setting this up, or work out how to monitor these. I found the .csv files in the documents folder but have no idea how these are used.

Can anyone help me?

Thanks,
Pete

Re: Utilising built in ADCs on nistune boards.

Posted: Tue Jul 04, 2017 11:32 am
by Matt
The boards do not have built in ADCs

What you can do is purchase the DLP A/D USB converter and then wire the AEM outputs into this and then use this to plug into your laptop and record all the outputs

A cheaper option is to use an Arduino and use the source code I put together in the DLP section of this forum

Re: Utilising built in ADCs on nistune boards.

Posted: Wed Jul 05, 2017 7:23 pm
by vanepico
Ah yes, that makes more sense, I'd much rather use a £3 arduino nano copy than spend £26 + £12 postage for the dlp! Thanks.

Re: Utilising built in ADCs on nistune boards.

Posted: Tue Jul 11, 2017 11:37 am
by Matt
Yeah works great, and much cheaper!