Utilising built in ADCs on nistune boards.

If it isnt a problem or a suggestion it probably goes here.

Moderator: Matt

Post Reply
vanepico
 

Posts: 30
Joined: Mon Jul 03, 2017 3:19 am

Utilising built in ADCs on nistune boards.

Post by vanepico »

Hi guys,

I'm looking to use my AEM uego, as well as an intake air temp and boost sensor with the 0-5v ADCs mounted on the nistune board, but I can't for the life of me find any information about setting this up, or work out how to monitor these. I found the .csv files in the documents folder but have no idea how these are used.

Can anyone help me?

Thanks,
Pete
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Utilising built in ADCs on nistune boards.

Post by Matt »

The boards do not have built in ADCs

What you can do is purchase the DLP A/D USB converter and then wire the AEM outputs into this and then use this to plug into your laptop and record all the outputs

A cheaper option is to use an Arduino and use the source code I put together in the DLP section of this forum
vanepico
 

Posts: 30
Joined: Mon Jul 03, 2017 3:19 am

Re: Utilising built in ADCs on nistune boards.

Post by vanepico »

Ah yes, that makes more sense, I'd much rather use a £3 arduino nano copy than spend £26 + £12 postage for the dlp! Thanks.
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Utilising built in ADCs on nistune boards.

Post by Matt »

Yeah works great, and much cheaper!
Post Reply