SR20DET KnockProblem

If it isnt a problem or a suggestion it probably goes here.

Moderator: Matt

Post Reply
FRimports
 

Posts: 12
Joined: Tue Dec 16, 2014 10:47 am

SR20DET KnockProblem

Post by FRimports »

Hy

My 200sx S14 sometimes spits the error ( DTC Knock ... )

The engine does not knock !

Can I use these values ​​here in order to edit the knock sensor is inoperative ?
Knock.png
(115.42 KiB) Downloaded 1937 times
Feedback Switch : Knock analysis IS OFF !

Thanks for your help!

Best regards
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: SR20DET KnockProblem

Post by Matt »

DTC is a fault code form the ECU. It does not mean the engine is knocking.

Perhaps there is a wiring issue to the ECU or a problem with the knock sensor itself. The code is raised when at anytime the knock sensor input goes out of range, so its a physical problem with the knock sensor

Disabling flags etc isn't going to fix a physical fault which is why the fault is raised. Refer to the factory service manual for checking this code
FRimports
 

Posts: 12
Joined: Tue Dec 16, 2014 10:47 am

Re: SR20DET KnockProblem

Post by FRimports »

exactly it is probably a problem with the cable,
I can not values easily adjusted so that the knock sensor does not get a knock signal more?
I drive anyway no klopfmap
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: SR20DET KnockProblem

Post by Matt »

Post Reply