R34 Rb25DET NEO map question

Discussions concerning the M7790 cpu

Moderator: Matt

Post Reply
AUSBen31
 

Posts: 23
Joined: Mon Dec 12, 2011 12:30 am

R34 Rb25DET NEO map question

Post by AUSBen31 »

Hey guys, have a quick question about the factory RB25DET NEO map as im currently revising my tune before skyline nationals.

I was wondering if anybody knows what each factory TP value is in vacuum/psi on the factory map. Ive marked where i think 0psi is however i may be wrong. If i could get this confirmed or a photo marked with vac/psi values to there correct TP values that would be awesome. Im not sure if this is able to be emulated / bench tested to figure it out.

Also i was wondering on a different note why my consult gauge of TP is only showing the larger value not the indexed value. (the value e.g [54] )
Attachments
Capture.PNG
(43.9 KiB) Downloaded 2408 times
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: R34 Rb25DET NEO map question

Post by Matt »

There is now a separate indexed gauge TP IDX which is the index to this map

TP = VQ lookup [MAF] / RPM * K constant

As your airflow increases, it will increase. As your RPMs increase it will decrease

TP does not match upto air pressure so it cannot be scaled like that.
AUSBen31
 

Posts: 23
Joined: Mon Dec 12, 2011 12:30 am

Re: R34 Rb25DET NEO map question

Post by AUSBen31 »

I see actually didnt know this thanks Matt,

I do have one other question which i only just found out, VCT on the neo is triggered by TP as well as RPM, what does everybody usually do after TP has been rescaled from bigger injectors and Z32, is there a correct way of calculating the new value for the VCT TP enable? Mine kicks in at about 3psi according to 'VCT SOL' check light
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: R34 Rb25DET NEO map question

Post by Matt »

Depending on the amount of TP movement, adjust the VCT TP by the same amount. So if K constant is adjusted by say +30% then add this to VCT TP
NeWT
 

Posts: 32
Joined: Tue Oct 07, 2014 8:18 pm

Re: R34 Rb25DET NEO map question

Post by NeWT »

So if K constant is adjusted by say +30% then add this to VCT TP
Add? I thought substract.
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: R34 Rb25DET NEO map question

Post by Matt »

If K constant increases 30%, then TP increases 30% so the correct adjustment for other TP related parameters and indexes would be also +30%
NeWT
 

Posts: 32
Joined: Tue Oct 07, 2014 8:18 pm

Re: R34 Rb25DET NEO map question

Post by NeWT »

Posted my opinion here.
Post Reply