NISTUNE disconnects on 1.2bar , 1bar is fine ... wth ?

Discussions concerning the M7790 cpu

Moderator: Matt

Post Reply
IceManPL
 

Posts: 45
Joined: Wed Apr 22, 2009 7:10 pm

NISTUNE disconnects on 1.2bar , 1bar is fine ... wth ?

Post by IceManPL »

Hi
Car: s14a.
Mods: Stock engine, gt2871, 300zx maf, 550cc injectors from subaru, 3" exhaust
Everything was fine at 0.5, 0.8, 1 bar (rare random disconnects, but not bad) and then at 1.2 bar nistune keeps disconnecting at 4000-4500 rpm.
Switching to stream mode give me a little more rpms, and disconnects at about 5000-5600 rpm.
Also closing map window, afr window and leaving only log window open helps a little - strange ...

I know the first answer, check the electrical ground ;) Seems ok ...

So what else to look for ?
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: NISTUNE disconnects on 1.2bar , 1bar is fine ... wth ?

Post by Matt »

I've updated this document today:
http://nistune.com/docs/Installation_an ... ostics.pdf

Every possibility is covered here.

Closing particular windows in the software should not affect anything with comms. Stream mode is more resistant to noise due to less checking of data and one directional information
Post Reply