Nistune Forums

what virtual dyno are you useing thanks?

z32 maf and hks740cc injectors go well,
i have this with std motor with cams and gtir t28 16psi and have heaps of headroom about 60% d/c i think

long term fuel trim and sort term fuel trim, ltft 128% means no change, 118% pulling fuel, 138% adding fuel stft 100% means no change, 90% pulling fuel, 110% adding fuel only works in closed loop, O2 flags on but its good tool to check how close your latency and k are say ltft was adding 8% fuel all...

jmac636 wrote:. Whats wierd is if I go back to 720 it runs super lean at idle now and didn't before. It would run slightly lean before at idle. I'm addicted to this tuning stuff I guess. I can never leave it alone.

LTFT and STFT maybe why

hi, my sr20det u13 1e000 is bogging down hard when it is cold, it has fixed timing of 10 deg after start up untill u get to 65 engine temp, i can find the tables for cold timing with tps on but none of these are with the tps off i think that the table i am looking for is "Idle/Decel RPM Gear Ti...

is there away of marking the log when you are recording(driveing)? so u can go back and have a look at it later on

i think i sore something somewhere, i thought it was spacebar probably wong.

if not all good,

thanks

can u run a lc1 in the serial port and run a dlp in the usb port with boost and egt at the same time with out putting the lc1 thru the dlp?


i wood like 2 keep my lc1 going thru the serial port and keep it separte from dlp, and keep the dlp running separte as well,

sweet, keen az

DLP Designs A/D Converter

can u buy this in oz somewhere?

$57 shipping to nz a bit much, will if i have to tho

0.10.9, i went for a 10km drive 2day and loged it , lc1, plms cable, all good so far from what can i see

whats the injector pulse width doing? it looks like it mite jump, maybe ttpmax is low

same az above, no dtc tho, just all red


1e000 u13

low afm voltage gose from o volts all the way to 327675 volts

thats some mean volts

Quote:
map highlighting is going fine but most of the tables are red and stay red

screenshot?

i wood but i dont know how to do a screenshot sorry .

0.10.3
low afm voltage trigger still maxed out

i just clicked it and nistuned stopped working and closed, ill try it again now. Yep definately locks up then closes. Its an Evil button

same