Nistune Forums

I have looked through all the data the car still runs on the old AFM and Mines ECU. Could I have wired the AFM in incorrectly? I do get voltage from it The TP does not seems to be Maxing also does the "TTP Pulsewidth Max" apply to the whole RPM range or just the narrow band at Idle? Becaus...

Hi Matt and the forum team. I have been have issues tuning my Type 1 board. First off at 0.5 bar boost the car would run into a brick wall at around 3000Rpm after logging some data supplied below it seemed my Stock Ca18det AFM was maxing at 5.1 volts (NIStune_2008-06-14_1459_53.csv) I have now insta...

Good Evening guys...

Will I be able to feed my Zeitronix ZT-2 lamda out-put into my non-lamda (non-cat) ECU?

I have looked through the service manual and its Pin 29 on the ECU , Just asking if anyone has done this

Hi...

I have a little more information on the MAF , I hoping you guys can help me wire it in and get the correct VQ

Diameter: 75mm
Sensor: AFM and AIT
Pins: 4 pins out marked A B C D

Thanks Matt.

One more question on your website somewhere there was a wiring guide to most MAF sensors. I can seem to find it can you post the link for me?

First off thanks to Matt for the great nistune software. I can safely say now that I have Maxed my stock MAF a long time ago anyway I bought a New MAF on a bit of an impulse and I think I may have screwed up and lost a lot of cash The Maf was said to be from a 3.0 V6 Nissan Maxima the part numbers a...

Hi Matt

Is there any update when this might become available for the CA18?

Good Afternoon guys. Sorry for asking but what Ca18DET runs the following bin "S13_CA18_MECD016B.bin" found with the programmer install What I can gather from the tune is that its could be an 8 port Ca18Det looking at the timing and fuel map and it seems to be a jap spec because of the spe...

Sorry got carried away with the dremel tool.

But It was just bell mouthed and polished

If I have modified the Stock CA18DET AFM can I compensate for this in the niztune software and if so how?

I personally cant wait for this feature to become available...