Nistune Forums

Matt wrote:See Type 4 hardware installation manual - Photo for Y33 model ECU jumpers in there

oh my god! how to check the work or not?
when I open the throttle, ignition -7. where the fault is?

Matt wrote:Jumpers on the ECU.... not jumpers on the Nistune board

what affect a jumper on the ECU? in what place they are, you can specify?

Check the two jumpers on rear of ECU are soldered properly. If the ECU shows 'factory' at any time next to ECU part number then it is not picking up the Nistune board probably because of one of these jumpers not connected properly http://s017.radikal.ru/i429/1409/20/2ad6c6f60b0b.jpg http://s019.rad...

These injectors are installed in my engine. I can not find the information. Do you have any information on these injectors. Performance and lagtaym.

tr0jan wrote:

Matt wrote:That looks okay. Can you post BIN file here?

of course

222.bin

Matt wrote:That looks okay. Can you post BIN file here?

of course

When you make changes to your tune - does it say 'Uploaded XXXX: XX' at the bottom of the screen? Does nistune show ECU ID: 23710-xxxxx (FACTORY) or REV: xx at top of the screen. I dont think your board is installed properly into your ECU and it is using factory settings How do I know if it is prop...

When you make changes to your tune - does it say 'Uploaded XXXX: XX' at the bottom of the screen? Does nistune show ECU ID: 23710-xxxxx (FACTORY) or REV: xx at top of the screen. I dont think your board is installed properly into your ECU and it is using factory settings http://s61.radikal.ru/i173/...

Either (a) Nistune board is not installed or (b) the jumper for using Nistune board has not been moved If the ECU shows ECU ID: 23710-xxxxx and then FACTORY it is not using Nistune board the fact is that this message does not always appear. Work in the program, after a while there is this inscripti...

How come your O2 sensor signal showing 1.72V ? refer to your photo. a signal from a broadband sensor, I have not corrected. A stock ECU should only see 0-1V O2 signal, if you connect the wideband 0-5V signal to your ecu, the AFR will be mess up. Did you tried disconnect the O2 signal to your ECU ? ...

Hello. How can I bring these values ​​into the program? afh90-02 , V / Hz 5.00 1741.77 4.91 1741.37 4.64 1474.93 4.45 1302.04 4.25 1145.05 4.06 1002.62 3.86 873.48 3.67 756.56 3.47 650.81 3.27 555.31 3.08 469.26 2.88 391.91 2.74 339.24 2.59 290.89 2.44 247.20 2.30 209.62 2.15 177.03 2.00 148.73 1.86...

louiswun wrote:How come your O2 sensor signal showing 1.72V ? refer to your photo.

a signal from a broadband sensor, I have not corrected.

PL wrote:Is fuel pressure OK?

PL

fuel pressure is ok, 3bar