Nistune Forums

at 0% throttle on decel fuel cut will be active, you can adjust this on a table when it happens and how much but when throttle is closed lean ratios off the scale are normal.

do you have a wideband? if you take some logs I am more than willing to help.

It is a ecutalk cable, I plugged it into a friends car which had an rb26 conversion and someone had wired the consult plug with the live and the earth the wrong way round. The ecutalk cable heated up and it looks like a component labelled c17f ? anyone know what it is?

I broke my consult cable by accident and I had to use a cheap one I had as a backup which I had used with nistune before but only for datalogging whilst using ostrich and it worked fine. Now I had to use this cheap one one with a nistune board and keeps disconnecting after a few seconds and then giv...

I didn't even see this post untill today, I tottally forgot I could try the rb20 ecu. Anyway as I had wired in the consult plug myself and due to whatever reason I mixed up the clk wire for the chk wire (I checked the wires a million times as well lol, sometimes these things happen haha) turns out t...

sounds like the z32 is in limp mode, have a look at the soldering in the z32 ecu and check fro damaged tracks.

I had a look at the 20+20 header and found that pins 2 and 4 show continuity and I checked they also show conituity at j010-j011 pads.

I can't see any visual shorts at the header itself or at the j011,j010.

I just installed the nistune board 40 pin header, moved jumper from j11-j10 and programmed the daughterboard with the 69f01 firmware and slotted it in to find there wasn't communication. Just some background -car is a ps13 with an sr20det swap from an s14 as far as I can tell. -Was previously runnin...