Nistune Forums

I'm just wandering about the latency they claim, isn't .416ms a bit low for 740cc injectors?

Hey guys.
Anyone running these injectors?
https://conceptzperformance.com/Cart/de ... hp?II=3977

Matt wrote:Use the Moates reset utility. Or use the 1.2.7 version of Nistune.

Too many changes to the ostrich corrupts its bank settings and they need resetting. I put in detect and fix in the 1.2.6 version of Nistune

Thanks, done.

Hi guys, I was just wandering if any of you had a similar experience. I've been using the ostrich emulator for a while now, initially I had a problem with the car cutting out after driving for a while, this got solved once I've installed a socket booster. But Friday whiles on the Dyno I lost connect...

Found the problem Stock o2 sensor voltage is 0.1 to 0.9V Innovate o2 emulation was 0.1 to 1.1V BUT !!! there is some strange offset in voltage, and nistune reported max 1.30V instead of max 1.1V. So ecu saw very often high voltage = rich and then leans out. So i changed innovate emulation to 0.05 -...

Had similar symptoms, seems to have been a bad earth/-.

Found the problem. :lol: :lol: It seems there is a bit of a problem with the analog outputs on my Innovate's which I was using for narrowband simulation, as soon as I reconnected the std narrowband everything was sorted. Another good thing that came from this is that I found another 4 small boost le...

I should read what's being said, sorry for a stupid question and thanks for clarifying.

Thanx Matt, I would presume that the cold enrich would be timing less the 15degrees?

Hi guys, I did do a quick search but with no real luck.
My car is running lean around 70degree C. Which table/s do I change, I do not want to change the main fuel map to much as the car runs o k during summer.

Matt wrote:
I could not find a soft cut for the z32 ECU. I've renamed soft to hard in the address definitions for this for the next version

Thanks Matt.

Sorry guys, Z32. I keep on running into the hard cut and been setting the soft cut with out luck.

I can only see/set the "Soft Rev Limit Stage 1", where do I find the Hard Cut?