Nistune Forums

We got jeff's car up and running very nicely yesterday. We found that a few adjustments were required such as tps and the battery voltage is low. 11.6vdc with both the electric water pump and electric fan on. The car rips at 8psi. Nistune performed flawlessly with several large datalogs taken. No di...

no.

Maf voltage doesn't match between the consult display and the vq map.

Got it working. The cpu header was wrong and the jumpers were set to nvram. It's late so I'll have to wait until tomorrow to go for a test ride.

Found a problem. On the CPU header, Pin 2 goes to pin 34 on the cpu, and pin 3 goes to 37. I'll swap those around and hopefully be up and running. Also the eprom jumpers aren't very clear in the installation instructions. I'm not sure which they go.

everything checked out. here's the logfile.

error screen capture

I get 960 ohms from pin 27 to pin 28 with the nistune board plugged in. Is that ok?

i tried stinky's binfile with no luck. i can change the config to a usb consult and i get an error. other than that it just says it doesn't connect.

windows is seeing the nistune board but no connection to nistune itself. any ideas?

Pic sent to your via email

matt: i don't have a pic of the maxima ecu guts. i've asked the tester to provide me with a few.

the binfile is a couple of posts up.

ok, when can i send him your email address?

can you list the ecu's that are now ready for testing?

i've got needs for :

rb20
maxima
ka24
rb26