Nistune Forums

5.12/.08=64 I'd say it's .08vdc.

I've tuned the skyline for 20psi so far. We replaced the stock injectors with 680cc units. All is going well. I have not tested out both maf readings and such. I will get to that the next time i get my hands on it. The problem is that there's no bnr .adr file in the latest release. Can I use on that...

higher value=longer opening time

those injectors have a latency of 4D from what I've seen.

In the constants section "PREIGNITION TIME" just below the k value and above the feedback control.

um........i couldn't find my consult cable....i found it now, so i'll be back at it on monday or tuesday....

After some small problems all we had time for was to alter the K value for the larger mafs. We took the stock mafs and placed them into 3" piping. I started the car and after warmup got a 19:1 afr. I increased the k by 26%. The rom had a kvalue of E9 so I increased to 127h and the afr's went ba...

Nistuning will start on sat a.m. I have a plms consult package. As I understand it I can use my romulator, the consult board, and nistune to tune.
Is that it?

Twin-turboZ wrote:Bernard,, what sensor are you using for Boost? original nissan from what?

i'm using the stock 280zxt mapsensor.

Stinky wrote:
If I remember correctly you can convert the TP to the more usable value used in the maps by dividing it by 256. Matt will need to confirm this.

That is correct.

I looked at my binfile and it's also got 00 at 2000h. If that helps any..... I haven't noticed any problem with how the car is running. I've only tried to connect to consult a few times so far and haven't had any problems.

Thanks for the chip Bryant. It worked perfectly right off the bat. Burned my current tune and went for a ride. Don't need the romulator to tune.......

haha nice video. You must hate your rear tires or something.

I'm heading to the dyno tomorrow with the intent to use the cursor follow option while doing some steady state tuning. Does it work? Do I select it and that's it?

the neutral switch on my auto works....i didn't think the ecu actual took note of that.........but everytime i drop it into neutral, the switch lights up.

attached is the mapguage.txt file that the techedge uses for the stock nissan 2.5bar map sensor.