Has anyone set up one of jbperf's peak & hold board with Nistune?
Considering installing one into a 1988 300zx Z31 turbo ecu.
Search found 4 matches
- Tue Dec 16, 2014 9:36 am
- Forum: General Nistune Discussion
- Topic: jbperf peak & hold boards, anyone using them?
- Replies: 0
- Views: 59832
- Fri Apr 29, 2011 7:14 am
- Forum: Type 1
- Topic: z31 low impediance injectors on 88 ECU: resistors & wiring
- Replies: 1
- Views: 1958
z31 low impediance injectors on 88 ECU: resistors & wiring
Hi, This probably has been covered. I'm about to install a set of RX7 low impedance injectors (using one of Jason's fuel rails) in my 88 Z31. I've read that to do this, I need to rewire the injector wiring harness back to the pre-campaign configuration (i.e., each injector end up with its own indivi...
- Sat Feb 26, 2011 3:11 pm
- Forum: Type 1
- Topic: O2 sensor type for Nistuned Z31 88 Turbo ECU
- Replies: 5
- Views: 3335
Re: O2 sensor type for Nistuned Z31 88 Turbo ECU
I see in the software manual that there are auxillary inputs within the software available for a variety of wideband 02 sensors. Anyway to get the ECU to communicate with those? Or are those just for the computer being used to do the tuning? Sorry for all the questions, I'm new to Nistune.
- Sat Feb 26, 2011 9:15 am
- Forum: Type 1
- Topic: O2 sensor type for Nistuned Z31 88 Turbo ECU
- Replies: 5
- Views: 3335
O2 sensor type for Nistuned Z31 88 Turbo ECU
This may have been covered before.
Which O2 sensor type should I use with my Nistuned Z31 88 Turbo ECU?
The stock Z31 88 turbo ecu set up used a narrow band Titania O2 sensor.
I'd really like to use a wide band if possible.
Thanks in advance.
Which O2 sensor type should I use with my Nistuned Z31 88 Turbo ECU?
The stock Z31 88 turbo ecu set up used a narrow band Titania O2 sensor.
I'd really like to use a wide band if possible.
Thanks in advance.