Nistune Forums

Hi Matt, I am about to change my injectors from the standard 370cc to 1000cc, I have read that I should do these two changes not just one so that the tables re-calculate correctly? I am thinking I will go 550cc first, and burn that then go from 550 to 1000cc and then burn that in? I am on the right ...

Matt you Legend......... been playing with the settings and now can build about 8psi on launch and wow so good, just working out the correct speed to cut it back off again

Cheers, James

Hey Matt, thanks for the information I have now got it working, had a bad ground connection on pin 60, I have used my old auto (snow/power) switch to trigger it and it works fantastically. On a strange note, when I turn my steering wheel at idle, my launch control will active and if I rev over 1200r...

Thanks Matt, do I need to have bits1 / 2 and 3 checked at the same time, as I have tried having just bit 2 and 3 and when I depress the switch, I see the power steering sw go green in the in the consult view. but my engine light doesn't flash. do I need to set the launch speed to maximum to enable t...

Thanks Matt, will give that a try tomorrow

Cheers, James

Ok guys update on the button problem...... well it turns out that I had a poor ground connection at pin 60 so that is sorted. when I ground the wire I see the Pwr steer sw light come on in my nisture software so that is a success :) Now the problem I seem to have is, when I select the launch control...

Ok so in my previous post I spoke about the button problems, now I can get the lauch control to work with the laptop plugged in and can set all the settings ok, but what seem to be failing at is building boost...... so without setting the rev limiter at something silly, 5k plus I am only able to get...

Hi Guys, I am trying to setup the moment button for my launch control and having all kinds of problems. so here are the specs, 1997 R33 rb25det S2 (auto) running a Z32 type 2 ecu, now in the documentation it tells me to connect my not used power steering input to a moment switch that grounds to pin ...

I think that you are using the wrong bin file. [Z32 (VG30DETT) Z32 (type2) feature Pack 1.0 (version:5) is the adress file for the ecu. So this is ok. @ main in the screenshot i see Nistuner33 23710 41P13AT looks like you are using a bin file for a Z32 ECU with a VG30DETT engine. This is also a bin...

Ok thanks on the O2, any ideas on the ecu compatibility?

Cheers, James

hi guys I have added a screen shot for the log

https://www.dropbox.com/s/6vsamu0v2jwdn ... 8.png?dl=0

cheers, James

Hi guys, I have a 96 R33 gtst, auto that i converted to a manual and have been using the auto ECU with out any problems, when I purchases the gearbox the guy had a nistune ecu with it. I sent it to Matt to it checked out, and all was ok with the type 2 install. I have just fitted it to the car and c...